Product Catalogue

Battery Switches - Motorised

 

BEP Marine Battery Switch Test

Procedures (UL 1107)

Continuous (1 hour)

Intermittent (5 minutes)

Cranking (engine starting – 10 seconds).

The test is to determine the maximum current the  switch can handle for the stated time, without the rear terminals exceeding 100°C (212°F) above the ambient temperature. The continuous and intermittent ratings are tested at 110% of specified ratings. All BEP switches are tested Independently to this specification by a 3rd party laboratory




ProductDescription
720-MDO-EP VERSION 8 - REMOTE OPERATED MOTORISED BATTERY SWITCH-500AMPS EMERGENCY PARALLEL FUNCTION 720-MDO-EP VERSION 8 - REMOTE OPERATED MOTORISED BATTERY SWITCH-500AMPS EMERGENCY PARALLEL FUNCTION

The 720-MDO-EP (Emergency Parallel Switch) provides remotely activated, high current, emergency...

720-MDO Version 8 - Remote Operated Motorised Battery Switch - 500 Amps 720-MDO Version 8 - Remote Operated Motorised Battery Switch - 500 Amps

The 720-MDO Version 8 has new installation options, whereby the motor/circuit board can be fed...

701 - MD-Remote Operated Motorised Battery Switch-275Amps 701 - MD-Remote Operated Motorised Battery Switch-275Amps

Due to the increased load requirements and large increases in the cost of copper battery...

80-724-0006-00 - Key Switch 80-724-0006-00 - Key Switch

For the remote operation of the 701-MD and 720-MDO motorised battery switch range. It can...

Wireless Remote Control System Wireless Remote Control System

Similar to a car remote, the BEP Wireless Remote Control system enables boaters to wirelessly...

80-700-0051-00 - Battery Control Center 80-700-0051-00 - Battery Control Center

The Battery Control Center is equipped with switch locks on each battery switch actuator. This...

Copyright © BEP Marine Ltd. All Rights Reserved
Web Design and Content Management by Benefitz